Call to get tree service such as tree romoval,


stump grinding, bush trimming, shrub mulching


or resolve any other tree related issues now:




Call now +1 (855) 280-15-30



The tool is made from threaded bar, two large washes, a number.



Mar 13, To replace the subframe bushings: Remove 4 bolt bolts holding subframe to diff, and 4 bolts+nuts holding trailing arms to the subframe. Remove the stock subframe bushing by making this setup on a bench vise: The sockets go in these slits.

Have a helper hold the subframe while you set everything up.



MGarrison, Jun 8,



Aug 01, When removing the rear subframe on an E30, there is always a possibility that either of the two old bushings will be oxidized and therefore seized/stuck in the body. The OE subframe bushings are made up of an aluminum sleeve with a thick rubber coating around it.





E30 Technical Forums; Suspension & Unsprung; If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. remove 2 socket head bolts that hold lower bushing plate (they are located just forward of the rear jacking point) with 24 inch rod and hammer, punch out bolt that runs inside of bushing (that's why you covered that rear area up - prevents flying bolts from damaging the leather!).

The back end of the E30, including the Drivetrain and the Brakes, are all mounted to one piece of metal known as the Rear bushremove.pw subframe is held in place with two bolts, cushioned with rubber bushes. Over time, these bushes will perish and fail, leaving you with sloppy suspension, four-wheel steering and some very suspicious knocking sounds. To get your driving experience back to how. Dec 31, e30 rear subframe bushings-replace or leave. Discussion in 'E30 ' started by 02m3smg2b, Jun 7, 02m3smg2b guest.

Replacing the rubber subframe bushings is not an easy diy job. You'll likely need a press to get new rubber ones in. trailing arm removal. e30 Subframe bushing puller tool.AM. Sub-Frame bushing puller for E30s and Z3s. I've used this tool to pull approximately 25 sets of bushings so this is a proven design that makes pulling sub-frame bushings an easy job. Price isshipped and the item ships from North Carolina.





© bushremove.pw | 375 376 377 378 379 | Privacy Policy